Get the manufacturer's name and the model number. Then Google them together. You might find a discussion, or a diagnostic sheet with greater detail (like, what do those blinks mean?) floating out there somewhere in the ether.
Get the manufacturer's name and the model number. Then Google them together. You might find a discussion, or a diagnostic sheet with greater detail (like, what do those blinks mean?) floating out there somewhere in the ether.
"The social contract exists so that everyone doesn’t have to squat in the dust holding a spear to protect his woman and his meat all day every day. It does not exist so that the government can take your spear, your meat, and your woman because it knows better what to do with them." - Instapundit.com
I'm an electrician bubs. Googling crap works nice except in the real world. And I mean no offense. I'm rather sarcastic. As if you don't know. Easier to replace the fixture. If I come out and replace the ballast at $100 per hour for the company and make it last two hours? You just paid $200 for a $30 light fixture. And I can and will tell any member on this board how to wire it up. For free.
“When bad men combine, the good must associate; else they will fall, one by one, an unpitied sacrifice in a contemptible struggle.” Edumnd Burke
electricians are a shady bunch...
Last edited by Atticus Finch; 05-18-2016 at 04:22 AM.
Bitter Clinger since 1957
The companies are. You don't think "I" get that $100 per hour do you? I get paid my hourly rate. I wanted to get the crap done and go goof off at Taco Cabana.
I actually never did estimates nor pricing. I can estimate what you need then I call into the shop for the parts. I was never on the money end. I was however always honest with my customers. If the shop is ripping you off, between you and them. Besides, I did mostly commercial. Out of 15 years I think I did service for 6 months. I basically install crap. I hated going in people's sloppy houses and working.
“When bad men combine, the good must associate; else they will fall, one by one, an unpitied sacrifice in a contemptible struggle.” Edumnd Burke
AC isn't my forte, but I would suspect that one of your lugs is not tightened. Turn off that breaker and see if one of your leads is loose.
I'm not sure, but I don't think you've got a ballast in an LED...? As far as I know, that's flourescent action with the good old 277's vicious bite.
Interdum feror cupidine partium magnarum Europae vincendarum
Is that on a dimmer switch? If so, crank it up to full power and see if it still blinks.
Interdum feror cupidine partium magnarum Europae vincendarum